Heat Pump installers Brecon.
Efficient, low-carbon heating — expertly installed.
We design and install air source heat pump systems that deliver comfortable, steady heat and reliable hot water working closely with our partners Sustainable Heating Wales. We provide clear advice, tidy workmanship, and support with grant routes where available.
Designed for comfort and efficiency
Heat pumps work!...When designed properly. A heat pump isn’t a “swap like-for-like” boiler job — performance depends on correct sizing, flow temperature, hot water setup and controls. We design around your home so it runs efficiently. Exoerts in building heat loss we meticulously size your system to improve our performance then with our trusted partners will install and maintain it to ensure peace of mind for years to come.
From quote to comfort
Initial conversation
We’ll ask about your current heating, hot water use, insulation, and what “comfort” looks like for your home.
Home assessment
We check heat loss, radiator/UFH suitability, cylinder options, and where the outdoor unit can be sited.
System design
Correct sizing and layout planning to keep flow temperatures low and efficiency high — not oversized, not underpowered.
Quotation
Clear pricing and scope. If upgrades are needed (e.g., radiator changes), we’ll explain why and price them transparently.
Installation
Neat pipe routes, safe electrics and tidy finishing. We keep disruption down and update you daily.
Commissioning & handover
We test operation, set controls, and show you how to run it efficiently (steady heat, sensible schedules).
Send your postcode and a couple of details — we’ll advise the best next step.
Why choose a heat pump?
The key advantages
Heat pumps move heat rather than generating it through combustion. When designed properly, they can run efficiently at lower temperatures and deliver consistent comfort.
Lower flow temperatures give an even warmth.
A step toward a lower-carbon home.
Works well alongside smart controls and good insulation.
We can talk you through typical requirements.
Often referenced grant figure for eligible air source heat pump installs (BUS).
Typical lifespan range with good installation and routine maintenance.
Efficient hot water via a cylinder setup and modern controls.
Best results usually come from:
A good heat loss assessment, sensible flow temperatures, correctly sized emitters (radiators/UFH), and well-tuned controls. We design the system around these fundamentals.
How heat pumps work
Air source heat pumps (ASHP)
An ASHP extracts heat energy from outdoor air and “upgrades” it so it can warm water for your radiators/UFH and hot water cylinder. Even on cold days there’s useful heat energy in the air.
Absorb
The outdoor unit absorbs heat from the air into a refrigerant.
Boost
The system compresses the refrigerant to raise its temperature.
Transfer
Heat is transferred into your heating water via a heat exchanger.
Deliver
Warm water circulates through your home and heats the cylinder.
What we check for suitability
Heat pumps work best when the home and system are designed together.
Room-by-room assessment to size the system correctly.
Radiators/UFH suitability for lower temperatures.
Cylinder sizing and plumbing layout.
Positioning, noise considerations, airflow clearance.
Installed work
Send your address and a few details — we’ll advise on a sensible system size.
Request a heat pump quote
Everything Energy Renewables Limited
99 Stanley RoadBootle
Liverpool
L20 7DA
Phone: 07502270626
Email: enquiries@everything-energy.co.uk
Hours: Mon–Fri 9-5
Service area
LiverpoolSouthport
Wirral
Widnes
St Helens
Manchester
Merseyside
Lancashire
Cheshire
Wales
Accreditations
